久久久久亚洲AV成人无码-国产美女久久精品香蕉69-国产综合久久久久久鬼色-久久这里只有精品18-亚洲女久久久噜噜噜熟女,亚洲精品色婷婷在线影院,亚洲一区在线二区,天堂中文在线资源库用,国产内谢xxxxxxxhd,亚洲中文字幕在线精品 ,国产一区 国产精品 精品三_国产精品一区二区久久宅男_国产亚洲美女精品2020久久久_91精品国产自产在线观看永久 ,久久久精品成人免费观看国产下-91精品人妻一区二区三区蜜桃-亚洲午夜精品专区国产-国产福利一区二区三区高清

行業新聞

當前位置:首頁 > 新聞中心 > 行業新聞

如何提高制氮機的使用壽命?

來源:http://m.556rte.cn/   日期:2020-08-12   瀏覽量:0
TAG:山東制氮機,山東干燥機,山東螺桿鼓風機,山東空壓機,山東自動排水器

保養對于任何機器而言都是非常重要的,可以有效延長制氮機的使用壽命。那么如何提高制氮機的使用壽命,下面山東制氮機的小編為大家介紹下:

Maintenance is very important for any machine, which can effectively extend the service life of nitrogen generator. So how to improve the service life of the nitrogen generator, the following small edition of Shandong nitrogen generator is introduced for you:

除了保養之外,正確使用制氮機對于延長機器設備也是至關重要的。

In addition to maintenance, the correct use of nitrogen generator is also essential for the extension of machinery and equipment.

1、關閉所有的電源開關,包括制氮機和氮?dú)馊肟陂y及取樣閥,等待系統和管道完全泄壓結束。調節氧分析儀進行取樣并將減壓閥壓力調節到1.0bar,調節取樣流量計,將氣量調至在1左右即可,注意采樣氣量不宜過大,開始檢測氮?dú)饧兌取?/p>


20171218111431120.jpg

1. Turn off all power switches, including nitrogen generator, nitrogen inlet valve and sampling valve, and wait for complete pressure relief of system and pipeline. Adjust the oxygen analyzer for sampling, adjust the pressure of the pressure reducing valve to 1.0 bar, adjust the sampling flowmeter to adjust the gas volume to about 1. Pay attention to the sampling gas volume should not be too large, and start to detect the purity of nitrogen.

2、在壓縮空氣壓力要達到0.7mpa以上之后,才能打開制氮機的截止閥,同時要注意觀察吸附罐的壓力變化情況和氣動閥的工作能否正常進行。

2. The stop valve of nitrogen generator can only be opened after the compressed air pressure reaches above 0.7MPa. At the same time, the pressure change of adsorption tank and the normal operation of pneumatic valve should be observed.

3、再生塔壓力為零,均勻時兩塔壓力應接近原工作塔壓力的一半。

3. When the pressure of regeneration tower is zero, the pressure of two towers should be close to half of the original working tower pressure.

4、關閉整個系統和系統各部分,在制氮機吸附罐壓力達到0.6MPa左右時,觀察制氮系統是否正常工作。

4. Close the whole system and all parts of the system, and observe whether the nitrogen generation system works normally when the pressure of adsorption tank of nitrogen generator reaches about 0.6MPa.

在閱讀的小編為大家介紹的如何保持制氮機的相關內容之后,是否已經有所了解,想要更多的相關內容,可關注我們公司網站:http://m.556rte.cn/后期會呈現更多的精彩內容。

After reading the introduction of how to maintain the relevant content of nitrogen generator, whether you have any understanding. For more relevant content, please pay attention to our website: http://m.556rte.cn/ More wonderful content will be presented later.


上一篇:
下一篇:山東空壓機高溫停機的原因是什么?

墨玉县| 怀远县| 新兴县| 和林格尔县| 沽源县| 方城县| 沐川县| 咸宁市| 宜章县| 台山市| 沂南县| 锡林浩特市| 娄底市| 麻江县| 车险| 锡林浩特市| 湟源县| 江阴市| 定安县| 永平县| 琼中| 玉龙| 鹿泉市| 紫云| 甘南县| 宣威市| 锦屏县| 锡林浩特市| 新密市| 襄垣县| 东阳市| 英吉沙县| 特克斯县| 渝北区| 东港市| 抚宁县| 西林县| 巧家县| 景东| 汾阳市| 富阳市|